Single E1/T1/J1 over IP/Ethernet extender – TDMoverIP – DC48V power
The IPM-1SE-DC48 unit can send one E1/T1/J1 interface over Ethernet using TDMoIP technology. IPM-1SE-DC48 is available with neg. DC (36-72V) power supply input. There are also AC and DC24V power supply versions available. The IPM-1SE can extend TDM networks using the Internet as transport network. Thus, cost effective solutions are available for deploying highly expensive TDM networks into areas with Internet coverage.
Features of IPM-1SE-DC48 access unit
- Supports synchronous TDM services and Ethernet over IP network
- Offers Ethernet cascading ability to increase the number of TDM interfaces
- Supports point-to-point E1, T1 or J1 over IP network transport
- Supports clock recovery for the E1/T1/J1 interface
- CLI, Telnet and SNMP management supported, upgradable firmware
- DC 36-72V power available with 3 screw DC power connector
Technical specifications
- Ethernet connectors: one RJ45 10/100Base-TX uplink port and one RJ45 10/100Base-TX LAN port
- TDM connectors: E1 (both RJ45 120ohms and dual BNC 75ohms), T1 RJ45 100ohms,
- Framing: Unframed, D4, ESF, PCM30, PCM31
- Data rate: 1544Kbps / 2048Kbps
- LEDs: PWR/ TD/ RD/ RTS/ DCD/ T-CLK Loss/ Red Alarm/ Sync Loss/ Yellow Alarm/ Err/ Test
- Power: DC 3 screw block 36-72V connector
- Temperature: 0-50§C (Operating), 0 – 70§C (Storage)
- Humidity: 5%-90% non-condensing
- Dimensions: 195mm x 235mm x 45mm
- Weight: 1600g
- Compliance: ITU-T G.703, G.704, G.706, G.732, G.823
- MTBF: 57,000 hours
Product Sheet:
- Data Sheet
- Installation Manual
